Train number displays

About

This page discribes different boards for display of six digit train numbers.

Communication

• LocoNet protocol to display a train number
• Table of implemented SVs

The different boards

• Board for Treudelburg with up to 5 dot matrix displays
• Board for Erbert frame with one dot matrix display
• Boards with 7-segment LED displays in Erbert frame
• Prototype SpDrS60 module from Philips

---

Treudelburg

Purpose This board holds up to five independant subsystems that are similar to the board for Erbert frames. It can be shortened to accommodate less than five displays. One subsystem has a ATmega8 controller and an HDSP-2112 8 character dot matrix display Interface 5V LotusNet, common message format for train number displays Status All boards are populated, software is nearly finished, first system test maybe Cloppenburg 2006.

---

Board for single HDSP-2112

Purpose This board holds one circuit similar to the five circuits of the board for Treudelburg. It was initially designed to be integrate into Erbert frames. But the likely use will be as EKA (Eingabekontrollanzeige) using four boards as user interface of the train number central computer to dail in numbers etc. Interface 5V LotusNet, common message format for train number displays or yet to be defined message for one quarter of an EKA. Status One board is populated and is currently used by Michael Weinert to develop the mechanical fitting as EKA. First system test maybe Cloppenburg 2006 or a shortly later ZN test meeting. Fotos First display prototype for integration in Erbert frame, connected to interlocking board Detail of first display prototype

---

7 segment display for Erbert frame

Purpose This display consists of two boards. One fits into an Erbert frame and holds six 7-segment-LED-displays. The second board accommodates a MAX7219 chip which can drive 8x8 multiplexed LEDs. Interface 5V, synchronous serial interface, similar to SPI. Status One board is populated. Software development on an additionally needed AVR will start after Bad Oeynhausen Fotos Parts: Erbert frame, base for board, the two naket boards, populated boards, panel Assembled, front side Assembled, back side

---

Prototype 7 segment display for SpDrS60

Purpose This display is part of ZNP800 systems delivered by Philips. It occupies one grid position in a Siemens SpDrS60 table. Interface Prototype interface board will be discarded, instead an SPI interace is used. Will be connected to SpDrS60 interface board. Status Prototype interface board will be manufacturered soon: Schematics Board Fotos Disassembled

FREMO Contents	FREMO_STW	ZNF800

Author of this page: Stefan Bormann.